Users browsing this forum: No registered users and 87 guests
Ship Tare Mass? | |
---|---|
by kenl511 » Wed Aug 03, 2016 3:33 pm | |
kenl511
Posts: 353
|
what is the mass of an empty cargo ship to mass fully loaded? If an 8Mton cargo is half the maximum mass its drive system can handle safely, that would mean 4 million metric tons. That is a lot for interstellar trade.
Same question for passenger liners. If a passenger liner masses 600,000 and the ratio is 9:1 or ship mass to passenger/crew specific allowance it would mean 60,000 tons allocated to the passengers and crew. Allocating 1 metric ton to each passenger and crew and a 1:1 crew:passenger ratio that would mean 30,000 passengers. That would translate to large floating cities running from orbit to orbit. And in HAE it would give a larger passenger complement on the passenger liner than the 3,500 listed. For Houdini, Jesyk Combine could easily acquire several passenger liners, park them in an out of the way location and load piecemeal for the evacuation. Or am I being way off on this? KISS would seem to prefer this. |
Top |
Re: Ship Tare Mass? | |
---|---|
by kzt » Wed Aug 03, 2016 4:06 pm | |
kzt
Posts: 11360
|
Ship mass in unknown, as it's actually a volume measurement expressed in tons because.
|
Top |
Re: Ship Tare Mass? | |
---|---|
by Joat42 » Wed Aug 03, 2016 4:08 pm | |
Joat42
Posts: 2162
|
You forgot *waves hands* --- Jack of all trades and destructive tinkerer. Anyone who have simple solutions for complex problems is a fool. |
Top |
Re: Ship Tare Mass? | |
---|---|
by Jonathan_S » Wed Aug 03, 2016 4:08 pm | |
Jonathan_S
Posts: 8792
|
Edit - damn, once again beaten by a more concise answer.
I think the simple answer is, we're not sure. The books do say that a wedge's acceleration is dependent on both volume and mass. But it appears to be vastly more dependent on volume. I know for warships, in the "Great Resizing" their dimensions were re-calibrated by applying a standard average density to their listed mass. Which in effect means that their mass is more like gross register tonnage for ships - really a measure of volume rather than displacement weight. Presumably freighters are measured the same way. So an 8Mton freighter is one with the same volume as an 8Mton warship. (However the only real data-points we have are the Trojan-class armed merchant cruisers (like Wayfarer) or one freighter from the SITS ship books. In both cases the tonnage seems basically inline with a warship of similar dimensions - though in both cases the merchant designs are shorter and fatter. But that only tells us their volume - not the max mass of cargo they can carry. I'd guess that at some point you'd start losing acceleration if, for example, you loaded a freighter up with solid lead (or gold) - but at what point it starts to matter; and its possible to stuff them with enough dense material to over-stress their drive just isn't known... |
Top |
Re: Ship Tare Mass? | |
---|---|
by ericth » Wed Aug 03, 2016 4:59 pm | |
ericth
Posts: 223
|
IIRC Himself said long ago that the compensator parameters are set when the ship is built, and set for a fully loaded ship.
Thus the accel is always for a fully loaded ship, even if it happens to be empty. |
Top |
Re: Ship Tare Mass? | |
---|---|
by Vince » Wed Aug 03, 2016 8:34 pm | |
Vince
Posts: 1574
|
We do have one data point, albeit incomplete (tonnage and acceleration only):
Italics are the author's, boldface is my emphasis. -------------------------------------------------------------
History does not repeat itself so much as it echoes. |
Top |
Re: Ship Tare Mass? | |
---|---|
by pnakasone » Wed Aug 03, 2016 9:28 pm | |
pnakasone
Posts: 402
|
Cargo ships rarely travel empty as they need a certain amount of cargo value just to break even. |
Top |
Re: Ship Tare Mass? | |
---|---|
by Jonathan_S » Wed Aug 03, 2016 11:56 pm | |
Jonathan_S
Posts: 8792
|
Good point. Even without her dimensions (which, being way before the Great Resizing, would be incorrect now anyway) that's still enough to indicate freighters and warships seem to be measured in the same tonnage scake |
Top |
Re: Ship Tare Mass? | |
---|---|
by Rincewind » Thu Aug 04, 2016 6:20 am | |
Rincewind
Posts: 277
|
But then there is the situation where you have the ship fully loaded & then you add mass onto it externally such as tractoring pods against the hull. From all the evidence I have read this does not seem to affect the acceleration, only when the pods are deployed clear of the wedge does the acceleration decrease. Thoughts anyone? |
Top |
Re: Ship Tare Mass? | |
---|---|
by Jonathan_S » Thu Aug 04, 2016 8:49 am | |
Jonathan_S
Posts: 8792
|
Interesting thought. We know the acceleration is more tied to the compensator field than the raw drive power; any warship, at least, appears t be capable of accelerating hard enough to overwhelm its own compensator and flatten its crew. My guess, for those few pods ships could "tractor inside their wedge", is that they were really tractor into them inside the compensator field (otherwise even BCs could have fit lots more inside their wedge. We know the ship's hull tapers down towards the drive nodes and, IIRC, that's because that area is subject to massive grav here during wedge startup. But I'd bet that that empty volume is still covered by the compensator; that you can't shape the field so precisely to exclude the cutback outside the tapers, while still including the hammerhead. That in effect you're always paying for that volume, even though you can't normally use it. But since the grav sheer seems to stabilize once the wedge is up, maybe that's where you can tractor some pods to avoid acceleration loss. If it's already compensated volume then putting a Pos there is nomdiffernt than filling a cargo bay (except that if you don't move them before raising (or lowereing?) the wedge you'll accidentally destroy the pods. But that's inference and guess. |
Top |